Digi Tech RP1000 Manual do Utilizador descarregar pdf (Página 11)

Rear Panel

1. Amp Loop Ground Lift

This Ground Lift switch can be enabled to help prevent unwanted hum or buzz caused by ground

loops between the RP1000 and external ampliﬁers/preamps.

2. Input

High impedance 1/4” instrument input.

3. Amp Loop

These 1/4” send and return jacks let you connect to an external preamp or ampliﬁer and use

the tone from these components instead of the internal ampliﬁers of the RP1000. A Ground Lift

switch is provided and can be enabled to help prevent unwanted hum or buzz caused by ground

loops between the RP1000 and external amplﬁers/preamps.

4. Stomp Loop

These 1/4” send and return jacks let you connect to an external stompbox effect pedal into one

of 2 different positions of the RP1000 effects path.

5. Ground Lift Switch

This switch lifts pin 1 from the XLR Mixer Outputs from all ground references. This may be nec-

essary to help solve troublesome ground loops that can cause hum in the system, especially when

both XLR and 1/4” outputs are used together.

6. Amp/Mixer Switch

This switch optimizes the 1/4” Line Outputs for connecting to either a guitar amp system or

directly into the inputs of a mixer.

7. 1/4” Line Outputs

These 1/4” outputs can be plugged into a guitar ampliﬁer or into inputs of a mixer or recording

device. The front panel Output Level controls the level of these outputs.

8. XLR Mixer Outputs

The XLR outputs are designed for connecting to a recording device or mixing console. These

outputs always have speaker compensation active as they are intended to be sent into full a range

audio system.

9. Headphone Output

Connect headphones here. Output optimized for use with headphones having 60 Ohms of

impedance or less.

10. Looper Control Input

This 1/4” TRS jack allow the optional FS3X footswitch to be connected for remote control of the

RP1000’s Looper feature.

11. USB Jack

The USB jack connects the RP1000 to a computer and provides two purposes. First it is used to

provide communication between the RP1000 and the X-Edit editor librarian software. Second,

it is used to stream four channels of audio (2 up / 2 back) to and from the computer when using

the RP1000 to record via the included Cubase

LE4 recording software or any DAW recording

application.

12. Power Jack

Connect the included power adapter here.

13. Power Switch

Used to turn the RP1000’s power on and off.

1 2 3 4 5 6 7 8 9 1 0 1 1 1 2 1 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Comentários a estes Manuais

Sem comentários

Digi Tech RP1000 Manual do Utilizador Página 11

Comentários a estes Manuais